Maintenance Manual (960-943) 3-7
Tests and Diagnostics
Others are the diagnostic tests. Move the cursor on the test item you want
to execute and press ENTER.
The following table shows the subtests names of each test.
After a subtest is selected, the following message may appear.
The meaning of each item is as follows:
■ Test Loop
Select No: After testing, the program returns to the screen to select Error
Stop and Test Loop item selection.
Select Yes: After testing, the pass count is increased by one, and the test is
performed again from the test top. Repeat the test until SHIFT
+ Q is entered.
The setting of Yes/No can be changed by pressing ENTER.
■ Error Stop
Select Yes: if any error occurs during the test, the test is suspended and
key input is required.
TEST
NO.
TEST
NAME
SUBTEST
No.
SUBTEST NAME
1 MEMORY 1 Main Memory Test
2 HDD/SSD
Tes t
1
2
3
4
5
Sequential Read Test
Partial Read Test
Address Jump Test
Address Uniqueness Test
Specify Address Test
3 Keyboard Test 1
2
Key-code Test
Touch Pad Test
4 LCD Panel
Tes t
1
2
3
4
LCD Panel Test
All dot on/off for LCD
H - pattern display
LCD brightness
5 Battery
Charge Test
- -
6 Fan Test - -
8 EXIT to TOP
Menu
To Next Page
Loading...
Need help?
General
