Morpheus Operation Manual132
COPY MENU
• Copy Layer
This function allows you to copy everything in the primary or second-
ary layer (or both) from another preset into the current preset. A
primary layer may be copied into the secondary layer and vice-versa.
Only parameters which are designated “primary” or “secondary” will
be copied. Parameters such as the LFOs or modulation routings will
NOT be copied.
There are five options available: Pri to Pri, Pri to Sec, Sec to Sec, Sec to
Pri, Pri & Sec (Both)
COPY LAYER P P
000 Preset Name
• Copy Filter
This function allows you to copy the filter settings for the primary or
secondary layer (or both) from another preset into the current preset.
Copy Filter copies the following parameters only: Filter Type, Filter
Level, Morph Offset, Filter Frequency Track (initial setting), Filter
Transform 2 (initial setting) and Filter Reverse.
There are five options available: Pri to Pri, Pri to Sec, Sec to Sec, Sec to
Pri, Pri & Sec (Both)
COPY FILTER P P
000 Preset Name
• Copy LFO
This function allows you to copy the LFO settings for LFO1, LFO2 or
both from another preset into the current preset.
There are five options available: 1 to 1, 1 to 2, 2 to 2, 2 to 1, 1 & 2
(Both).
COPY LFO 1 1
000 Preset Name
••• Data copied from the
same preset will come from
the saved version of the
preset, NOT the edited
version. This could be used as
a “Revert” feature if you
make a mistake while
editing.
0
0
0
To Next Page
Loading...
Need help?
General
