Chapter 6: Hyperpreset Menu 61
• Zone Volume and Pan
This function sets the Volume and Pan position for each zone. Volume
allows you to adjust the relative volume between presets and pan
allows you to change the position of each zone in the stereo field. The
Volume control acts as an attenuator on the preset volume. It cannot
increase the volume past the setting programmed in the preset. The
Pan control adds algebraically to the pan value programmed in the
preset. Therefore if the preset pan setting is -7, (full left) a hyperpreset
pan setting of +14 would move the sound to (+7) the extreme right side
of the stereo field.
Position the cursor under the zone number and use the data entry
control to change the zone number. Position the cursor under the
volume or pan number and use the data entry control to change the
value for each zone.
VOLUME PAN Z01
127 +00
• Zone Key Range
Key range sets the keyboard range associated with each of the sixteen
possible zones. The key range of each zone can be set anywhere from
key C-2 to G8.
By placing the key ranges next to each other on the keyboard, multiple
instruments can be accessed simultaneously. This is called “splitting”
the keyboard because the keyboard is literally split up into different
sections each containing a different sound.
If multiple presets are placed on the same range of the keyboard, they
will all be played simultaneously. This is called “layering” since mul-
tiple presets are layered on top of one another. This results in a very
dense, “fat” sound.
KEY RANGE Z01
C-2 -> G8
HYPERPRESET MENU
To Next Page
Loading...
Need help?
General
