Chapter 6: Hyperpreset Menu 63
• Zone Velocity Offset
This function works in conjunction with the Zone Velocity Range
feature and adds a programmable offset value to the velocity value
applied to the preset. The velocity offset is variable for each zone from -
126 to +126.
Suppose that a preset is assigned a velocity range of 000-026 (see previ-
ous screen). If the preset was programmed with velocity to volume or
tone, the low velocity range will make the preset soft and muted. By
offsetting the velocity value to the preset by +100, the preset will
receive velocity values of 100-126 instead of 000-026 and the preset
will sound normal again.
VEL OFFSET Z01
+000
• Zone Transpose
The key of each zone can be transposed in half-step intervals. The
range of the transpose function is ±36 semitones (three octaves up or
down). Transpose shifts the relative position of the keyboard in rela-
tion to middle C rather than actually changing the tuning of the zone.
TRANSPOSE Z01
+36
• Zone Pitch Tune
The tuning of each zone can be adjusted in coarse and fine increments.
The coarse tuning adjustment tunes the zone in semitone increments.
This is different from the transpose function in that the sounds are
actually retuned, rather than having the relative key position changed.
This control can produce radical timbre shifts in the sampled sounds.
The range of the coarse tuning control is ±36 semitones (±3 octaves).
The fine tuning control changes the pitch in 1/64 semitone increments
(approx. 1.56 cents). The fine tuning range is ±1 semitone.
PITCH TUNE Z01
crse+36 fine+64
HYPERPRESET MENU
▼ If the Auto-Select function
(in the Master Menu) is
turned On, Zones will be
selected as the keyboard is
played.
To Next Page
Loading...
Need help?
General
