Eads TGR990 - Powering On;Off; Powering on (Emergency Key); Powering on with Transmit Inhibit (TXI) Active

Getting started
16
• and are used to initiate or answer calls, end calls or
send status and text messages.
• The LED indicates the states of the TGR990 radio.
Q Powering on/off
To power On :
• Press and hold the Rotary Knob .
• If the TGR990 is configured with ignition sense, the radio will
automatically turn on whenever the vehicle ignition is turned on.
Your TGR990 radio performs a self-check and registration routine.
After successful registration, the TGR990 will be in service.
The display shows Idle screen.
To power
Off :
• Press and hold the Rotary Knob .
Q Powering on (Emergency key)
Press and hold to power On . The TGR990 will power On in
Emergency Mode or in standard mode (as programmed).
Note: The terminal powers On and Off without visible and
audible notification if Silent Emergency Mode is activated.
Q Powering on with transmit inhibit (TXI) active
Transmit Inhibit (TXI) is a feature allowing you to switch off
transmission before entering a Radio-Frequency (RF) sensitive
area. To activate this feature, press the menu key
and select
Setup → Networks → TXI Mode → Activate.
Warning: Pressing , even if Transmit Inhibit is activated,
causes the TGR990 to transmit immediately. The TGR990 must
NOT be within the RF sensitive area when entering Emergency
Mode.
MENU
TGR990_features.book Page 16 Thursday, December 3, 2009 9:43 AM