Eads TGR990 - Setting the Wallpaper

The menu
74
Screen saver
1. From the Main menu , select Setup → Display → Screen Saver.
2. Press
Change . Press Change again and select the screen saver
setting: Auto
or Disabled. If set to Auto the screen saver turns on
after 30 seconds of inactivity.
3. Scroll to Text:. Press
Change . Type/edit the screen saver text
using the keypad. For details on text editor use, see Writing text
on page 86.
4. Press
Done to exit.
Setting the backlight
You can set the function and brightness of the backlight. To enter
your backlight settings sub-menu:
1. From the
Main menu , select Setup → Display → Backlight:.
2. Press
Change .
3. Select required setting.
• Function — your TGR990 has 4 backlight settings:
• Auto — Any key press turns the backlight on. The backlight
remains on until the pre-programmed timer runs out.
• Disabled — The backlight feature is disabled.
• Semi Auto — Per default the backlights are switched off. You
can switch the backlights on by pressing . After a few
seconds (configured by your Service Provider) the backlights
switch off automatically.
• Manual — The backlight remains on. To turn the backlight on/
off press .
• Brightness — you can set the brightness to High or Low.
Setting the wallpaper
1. From the Main menu , select Setup → Display → Wallpaper:.
2. Press
Change .
3. Select required setting (On/Off).
TGR990_features.book Page 74 Thursday, December 3, 2009 9:43 AM