Eads TGR990 - Making Calls; Receiving Calls; Enabling PIN Activated

Getting started
26
Q Making calls
See Making a group call on page 30 for TMO operation, Making a
group call on page 35 for DMO operation, Making a private call on
page 37, and Making a phone or PABX call on page 39.
Q Receiving calls
The TGR990 will automatically receive the incoming call.
Additionally, if Inactivity Revert Mode is enabled, the TGR990
returns automatically to the Home display, after that call ends.
Note: Inactivity Revert Mode will occur if configured by your
Service Provider.
Your TGR990 will alert you of an incoming call depending on the
setting you selected in the Tones menu option (see Display features
on page 73).
During message editing, you will be alerted of an incoming Group/
Emergency/Broadcast Group Call if configured by your Service
Provider.
Q Enabling PIN activated
To activate features (for example: GPS, Gateway, Repeater, Multi
Slot packet data) use the PIN codes that were supplied with the
radio.
To enable features:
1. Turn off radio.
2. Press and hold green PTT and .
3. Turn on radio.
4. Select feature from the list and enter feature pin code.
Note: You can repeat step 4 to select more then one feature.
5. Turn off radio.
TGR990_features.book Page 26 Thursday, December 3, 2009 9:43 AM