Eads TGR990 - Unlocking the TGR990; Selecting Your Network; Looking after Your TGR990; The Display

Getting started
17
Press the Yes soft key to deactivate the TXI Mode. If the TGR990
was previously used in Trunked Mode, it will register to the network.
If the TGR990 was previously used in Direct Mode, it will remain in
Direct Mode.
Press
No in Trunked Mode and the TGR990 powers down.
Press
No in Direct Mode and you remain in Direct Mode with TXI
selected.
Q Unlocking the TGR990
The TGR990 may be locked at power up.
To unlock the TGR990 after powering on, enter the code at the
prompt. The TGR990 enters the default Home display.
The unlock code is originally set to 1234. Your Service Provider may
change this number before you receive your terminal.
Q Selecting your network
Before you start operating your TGR990, you can select the network
you want your TGR990 to be registered to. For detailed information,
see Networks on page 68.
Q Looking after your TGR990
To clean your TGR990, use a moistened or antistatic cloth. DO NOT
use a dry or electrostatically charged cloth.
Q The display
Home (idle) display
A powered-on, idle terminal shows the following typical Home
display:
TGR990_features.book Page 17 Thursday, December 3, 2009 9:43 AM