Eaton MVX9000 - Braking; Table C-3: All Braking Resistors & Braking Units Used in AC Drives

Braking
C-4 MVX9000 User Manual
Accessories
Braking
Note: Please only use Eaton’s recommended Cutler-Hammer values. Other
resistors values will void the warranty. Please contact the nearest Eaton
representative near you for use of the special resistors. The resistors should be at
least 10 cm away from AC drive to avoid possible noise.
Table C-3: All Braking Resistors & Braking Units Used in AC Drives
Note: Using resistors other than the value stated will void the warranty.
Voltage
Applicable
Motor
Braking
Resistor
Kit P/N
Qty of
Resistors
in Kit &
Wiring
Total
Resistance
and Wattage
applied to
MVX
Full Load
Torque
(kgf-m) of
System
Braking
Torque
@
10%ED
with Kithp kW
115V
Series
1/4 0.20 K13-000034-0821 1 80W 200Ω 0.108 220%
1/2 0.37 K13-000034-0821 1 80W 200Ω 0.216 220%
1 0.75 K13-000034-0821 1 80W 200Ω 0.427 125%
230V
Series
1/2 0.37 K13-000034-0821 1 80W 200Ω 0.216 220%
1 0.75 K13-000034-0821 1 80W 200Ω 0.427 125%
2 1.5 K13-000034-0824 1 300W 70Ω 0.849 125%
3 2.2 K13-000034-0824 1 300W 70Ω 1.262 125%
5 3.7 K13-000034-0825 1 400W 40Ω 2.080 125%
7-1/2 5.5 K13-000034-0826 2 in Parallel 500W 30Ω 3.111 125%
460V
Series
1 0.75 K13-000034-0841 1 80W 750Ω 0.427 125%
2 1.5 K13-000034-0843 1 300W 250Ω 0.849 125%
3 2.2 K13-000034-0843 1 300W 250Ω 1.262 125%
5 3.7 K13-000034-0844 1 400W 150Ω 2.080 125%
7-1/2 5.5 K13-000034-0845 2 in Parallel 500W 100Ω 3.111 125%
10 7.5 K13-000034-0846 3 in Parallel 1000W 75Ω 4.148 125%
575V
Series
1 0.75 K13-000034-0851 1 300W 400Ω 0.427 125%
2 1.5 K13-000034-0851 1 300W 400Ω 0.849 125%
3 2.2 K13-000034-0852 600W 200Ω 1.262 125%
5 3.7 K13-000034-0852 600W 200Ω 2.080 125%
7-1/2 5.5 K13-000034-0852 600W 200Ω 3.111 125%
10 7.5 K13-000034-0853 2000W 100Ω 4.148 125%