Eaton MVX9000 - Figure 5-4: Programming Mode; Figure 5-5: Parameter Changes

Viewing and Changing Parameter Settings
MVX9000 User Manual 5-3
Descriptions of
Parameter Settings
Use the ENTER key to enter the programming mode. The displayed parameter
will flash indicating the parameter can be changed.
Figure 5-4: Programming Mode
Use the up and down keys to change the parameter setting. Press ENTER to enter
the new parameter setting.
If the parameter change is successful, the keypad will display the end (End)
message and return to the parameter number display. If the parameter change is
unsuccessful the keypad will display an error (Err) message, the parameter will
not be changed, and the parameter number will again be displayed.
Note: Some parameters cannot be changed while in the RUN/START mode.
Figure 5-5: Parameter Changes
To exit the programming mode, press the left arrow key to return to the display
mode.
H
F
STOP
RUN REVFWD
U
A
H
F
STOP
RUN REVFWD
U
A
H
F
STOP
RUN REVFWD
U
A
Successful
Parameter Change
Unsuccessful
Parameter Change