Step-by-Step Installation
4-2 MVX9000 User Manual
Start-Up
Procedures
This chapter will explain the installation of the MVX9000 Microdrive. Be sure to
read and follow all instructions for a successful installation.
Step-by-Step Installation
1. Read all instructions and warnings associated with mounting the MVX9000.
2. Select a suitable mounting location.
3. Check the inverter mounting dimensions for footprint and mounting hole
locations.
4. Connect the wiring for the inverter input.
5. Connect the wiring to the motor.
6. Perform a power-up test.
7. Make observations and re-check the installation.
Mounting Location
Step 1: Study the following caution messages associated with mounting the
inverter.
WARNING!
This equipment should be installed, adjusted, and serviced by qualified
electrical maintenance personnel familiar with the construction and
operation of the equipment and the hazards involved. Failure to
observe this precaution could result in bodily injury.
CAUTION!
Be sure to install the unit on flame-resistant material such as a steel
plate. Otherwise, there is the danger of fire.
CAUTION!
Be sure to install the unit on a perpendicular wall which is not subject
to vibration. Otherwise, it may fall and cause injury to personnel.
CAUTION!
Be sure not to let the foreign matter enter vent openings in the
inverter housing, such as wire clippings, spatter from welding, metal
shavings, dust, etc. Otherwise, there is the danger of fire.
To Next Page
Loading...
