4-12 MVX9000 User Manual
Start-Up
Procedures
Powering the Inverter
If you have followed all the steps, cautions and warnings up to this point, you’re
ready to apply power. After doing so, the following events should occur:
• The numeric (7-segment) LEDs will illuminate.
• The Hz, Stop and Fwd LEDs will illuminate.
If the motor starts running unexpectedly or any other problem occurs, press the
STOP button. Only if necessary should you remove power to the inverter as a
remedy.
Note: If the inverter has been previously powered and programmed, the LEDs
(other than the POWER LED) may illuminate differently than as indicated above.
If necessary, you can initialize all parameters to the factory default settings. See
the initialization instructions in the Programming section.
To Next Page
Loading...
