EDAN M8 Series User Manual

Patient Monitor User Manual Alarm Information
- 62 -
Message
Cause
Alarm level
What to do
weak.
NIBP
Interference
Due to motion, signal
noise is too large or
pulse rate is not
regular.
Low
Make sure that the patient
under monitoring is
motionless.
NIBP Range
Exceeded
Maybe the patient
blood pressure value
is beyond the
measurement range.
High
Maybe the patient blood
pressure value is beyond the
measurement range.
NIBP Loose Cuff
Cuff is no properly
wrapped or no cuff
exists.
Low
Properly wrap the cuff.
T1 SENSOR OFF
Temperature cable of
TEMP channe1 may
be disconnected from
the monitor.
Low
Make sure that the cable is
properly connected
T2 SENSOR OFF
Temperature cable of
TEMP channe2 may
be disconnected from
the monitor.
Low
Make sure that the cable is
properly connected.
T1 EXCEED
TEMP1 measuring
value is beyond
measuring range.
High
Check sensor connection and
patient condition
T2 EXCEED
TEMP2 measuring
value is beyond
measuring range.
High
Check sensor connection and
patient condition
TEMP COMM
STOP
TEMP module failure
or communication
failure
High
Stop using measuring
function of TEMP module;
notify biomedical engineer or
Manufacturer’s service staff.
T1 Calibration
Failed
T1 Calibration Failed
High
Please check whether the
module works properly.
T2 Calibration
Failed
T2 Calibration Failed
High
Please check whether the
module works properly.
IBP1 SENSOR
OFF
IBP cable of channel
1 falls off from
monitor.
Medium
Make sure that cable is
properly connected.
IBP2 SENSOR
OFF
IBP cable of channel
2 falls off from
monitor.
Medium
Make sure that cable is
properly connected.
IBP(1,2) COMM
STOP
IBP module
communication failure
High
Stop using measuring
function of IBP module,

EDAN M8 Series Specifications

General

Brand	EDAN
Model	M8 Series
Category	Measuring Instruments
Language	English