15Installation and Service Guide: Color Controller E-85
Installing hardware
Remind site administrator to install current user software on client computers that print to the E-85 (see Printing and
Utilities, which are part of the user documentation set).
To change the E-85 language
1 Access Configure (see page 28).
2 In Configure, click Fiery Server > Regional Settings,
3 In the Server Language drop-down list, select a language.
4 Click Save.
5 Click Continue, then click Reboot.
Wait until the E-85 reboots and becomes Idle. It may take up to 15 minutes to complete the system language change.
Checking the customer site
Before you install the E-85, check site conditions and inform the customer of any installation requirements.
To check the customer site
• Is the printer configured for use with the E-85?
For correct settings, see the documentation that accompanies the printer.
• Is there adequate space for the E-85 near the printer?
Make sure there is enough space at the back and on both sides so that cables do not interfere with use or service of the
printer (for example, clearing a paper jam).
Figure 1: Space requirements for the E-85 without optional furniture
120cm+ (8 in.)
2E-85
3 Connector panel
1
3
4
1
2
2
1
3
6
6
5
Top view Left view
To Next Page
Loading...
Need help?
General
