25Installation and Service Guide: Color Controller E-85
Installing hardware
Power synchronization
You can enable the power synchronization feature using the switch on the printer interface board. The default switch
position is OFF.
When you enable power synchronization, the E-85 synchronizes power with the printer’s main power off/on status. If the
printer powers off, the E-85 receives signals from the printer through the USB cable connected to the printer interface
board, and automatically starts the shutdown process. If the E-85 receives the startup signals from the printer, the E-85
automatically powers on and begins the startup sequence.
When you enable power synchronization, the E-85 synchronizes power with the printer’s main power off/on status. If the
printer powers off, the E-85 receives signals from the printer through the printer interface cables connected to the printer
interface board, and automatically starts the shutdown process. If the E-85 receives the startup signals from the printer, the
E-85 automatically powers on and begins the startup sequence.
To enable the power synchronization feature at the E-85
1 Shut down the E-85 (see page 38).
2 Set the switch on the printer interface to the ON position.
Figure 9: Power synchronization switch
3 Power on the printer.
The E-85 will automatically start up.
Important: After the power synchronization is enabled, make sure to control the E-85 power using the printer.
Important: Do not change the switch position when the E-85 is powered on.
To Next Page
Loading...
Need help?
General
