104Installation and Service Guide: Color Controller E-85
Troubleshooting
• Make sure that each connector is properly aligned with its mating connector. If the pins are offset from each other, the
board affected will not function properly.
3 Reassemble the E-85 and verify its functionality (see page 83).
Inspecting the system
If checking cable and board connections does not fix the problem, consider inspecting the system component by
component (see Table 5) and verifying that each hardware component is properly installed and configured before you
decide to replace costly components.
If a component in the system you are servicing does not meet a condition listed in Table 5 and it is not clear how to fix the
problem (for example, if the system hangs before reaching Idle), locate the behavior in “Table 6: E-85 error messages and
conditions” on page 109 to see the suggested action(s) for solving the problem.
To Next Page
Loading...
