26Installation and Service Guide: Color Controller E-85
Installing hardware
To disable the power synchronization
1 Turn off the printer using the main power switch.
Wait until the E-85 shuts down.
2 Make sure that the power switch on the connector panel of the E-85 is OFF position (|).
3 Set the switch on the printer interface board to the OFF position.
Start the E-85 (see page 38).
Completing the installation
To complete the installation of the E-85 at the customer site, do the following:
1 Print the Test Page and Server Configuration page (see “Printing E-85 pages from the monitor, keyboard, and mouse”
on page 27).
2 Ask the customer to verify the output.
3 Perform any required system upgrades. For instructions, see the documentation that accompanies the system upgrade.
4 Ask the site administrator to perform Setup and print some test documents over the network.
5 Store the output and the current Server Configuration page(s) near the printer.
6 After the site administrator completes Setup, use the Fiery System Installer to copy the contents of the E-85 hard disk
drive to an image file.
Fiery System Installer is provided in System Software DVD 1. For detailed instructions, see “Installing system
software” on page 97.
7 Inform the site administrator that E-85 user software must be installed on networked computers that print to the E-85.
8 Ask the site administrator to make sure that all media shipped with the E-85 is stored in a safe location, accessible to
you.
9 For additional installation instructions, see the service documentation that accompanies the E-85.
Important: Do not change the switch position when the E-85 is powered on.
To Next Page
Loading...
Need help?
General
