77Installation and Service Guide: Color Controller E-85
Replacing parts
If you are replacing a hard disk drive with a new one, you must have the following:
• The appropriate system software and documentation for the E-85 you are servicing
• A compatible version of the user software for the networked computers that will be printing to the E-85
Servicing hard disk drives inside the E-85
This section describes how to remove and replace hard disk drives installed inside the E-85.
The hard disk drives are identified as follows:
• HDD1 is the 500GB hard disk drive installed in the top slot of the chassis. HDD1 is partitioned into drive letters c:\ and
d:\.
• HDD2 is the 2TB hard disk drive installed in the middle slot of the chassis.
• HDD3 is the 2TB hard disk drive installed in the bottom slot of the chassis. HDD2 and HDD3 are configured together
as a single RAID drive, represented by drive letter e:\.