38Installation and Service Guide: Color Controller E-85
Using the E-85
Starting, shutting down, restarting, and rebooting
Generally, you can leave the E-85 and the printer running all the time. Restarting the E-85 resets the E-85 system software,
but does not reboot the entire system. Network access to the E-85 is temporarily interrupted and all currently processing
jobs are terminated.
To start the E-85
1 Make sure that the power switch on the back of the E-85 is in the ON (|) position.
Figure 18: E-85 power switch
2 Power on the E-85 using the power button ( ) on the side of the display panel.
Press once and release the button to power on the system. The power supply automatically senses the correct voltage.
Figure 19: E-85 power button
3 Check the Fiery QuickTouch display panel.
Allow startup to proceed without interruption. Do not press any buttons while the system is starting.
Important: Unless instructed otherwise by a troubleshooting procedure, always shut down the E-85 from the Fiery
QuickTouch monitor or from the monitor attached to the E-85. Do not use the power button on the side to shut down
the E-85.
To Next Page
Loading...
Need help?
General
