41Installation and Service Guide: Color Controller E-85
Using the E-85
3 From the Home screen of the printer touch panel, select EFI Fiery. If the EFI Fiery icon does not display, move to the
other screen by swiping the screen until the EFI Fiery icon appears.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the
shutdown procedure.
Note: Notify the network administrator before you remove the E-85 from the network.
4 Press the Fiery tab.
5 Press Restart Fiery.
6 At the next screen, select one of the following options:
• Restart Fiery Service (soft reset)—Resets the E-85 server software but does not reboot the entire system. Network access
to the E-85 is temporarily interrupted and all currently processing jobs are aborted and may be lost. If you choose this
option, you may need to wait 1 minute or more for the server software to reset.
• Reboot System (hard reset)—Shuts down all E-85 activity properly and then reboots. Network access to the E-85 is
temporarily interrupted and all currently processing jobs are aborted and may be lost.
• Shut Down—Shuts down all E-85 server software and powers off the system. You should always select this option
when you want to power off the system. Network access to the E-85 is terminated and all currently processing jobs are
aborted and may be lost.
Note: Use the reset button on the front of the E-85 only if the system is unresponsive to keyboard or mouse actions.
7 Press OK.
To Next Page
Loading...
Need help?
General
