10-8 DICOM
Name Description
[Add]
Add the DICOM service to the service list.
[Cancel]
Click to cancel the parameter setting.
[Update]
Select an item in the service list, change the parameters in
the above area, and click [Update] to update the item in the
service list.
[Delete]
Click to delete the selected service in the service list.
[Default]
Select an item in the service list, click [Default] and you can
see !Y" in the Default column.
[Verify]
Click to verify if the two DICOM application entities are
normally connected.
[Exit]
Click to exit the screen.
Parameter setting should be consistent with the printer performance:
z For instance, if the printer cannot support film size to be !8IN*10IN", please select the
printer supported size.
z Settings: RGB is color printing and MONOCHROME2 is black and white printing.
z Medium Type: for black and white printing, usually Blue Film or Clear Film is used,
and for color printing, Paper is usually used. For details, please refer to printer
conformance statement.
z Change the setting if necessary.
10.1.3.3 DICOM Worklist
1. Enter [Setup]-> [DICOM Preset]-> [Set DICOM Service]-> [Worklist].
2. Select device, enter the information. For device setting, please refer to !10.1.3 DICOM
Service."
z Click [Add] to add the service to the Service list;
z Select an item in the service list, change the parameters in the above area, and click
[Update] to update the item in the service list; click [Cancel] to cancel changing.
z Select an item in the service list, and click [Delete] to delete the service.
z Select an item in the service list, and click [Default] to set the server to be the default
service.
3. Select an item in the service list, and click [Verify] to verify the connection.
4. Click [Exit] to confirm the setting and exit the page.
To Next Page
Loading...
