Elektron MULTISPOT MI-100control - Switching off the cooling water pump; Important information concerning welding

Resistance welder MULTISPOT MI-100control
Operation
53
6.4.5 Switching off the cooling water pump
You may stop the cooling water pump and weld current at any
time. Just press “Esc”.
(E. g. to change the electrodes).
Fig. 71: Message S09
After the pump has stopped, the display will shows the
message “S09“ (Fig. 71).
CAUTION!
Build
-
up
of heat may cause damage to property.
If the cooling water pump is switched off at the end of a welding job, heat may build up
and entail damage to property.
Therefore:
 Allow the pump to go on for at least 10 mins. After you have finished a job.
6.5 Important information concerning welding
Electromagnetic fields
DANGER!
Electromagnetic fields pose a potentially fatal hazard to people with
pacemakers or other magnetisable implants.
Electromagnetic fields affect the functionality of pacemakers and other magnetisable
implants. Electromagnetic fields can irritate human sense organs, nerve and muscle
cells.
Therefore:
 Persons with pacemakers or other magnetisable implants must not approach the
working area.
 Be sure to put up suitable warning signs.
 Be sure to put warning signs on access ways and doors leading to the work area.
 Do not guide welding cables along people’s heads or spines. Keep a distance of at
least 2 cm.