Resistance welder MULTISPOT MI-100control
Operation
41
Aligning electrodes
Fig. 41: “Electrode must be in true alignment”
Be sure to look from different angles. Electrodes must
align no matter how you look.
Additional explanation on the welding plier, see separate operating manual.
6.1.3 Checks before switching on
employees may hurt themselves and others. Inexpert
operation constitutes a hazard of injuries!
Inexpert and / or negligent handling of this equipment and / or ignorance of hazards and
dangers may entail the most severe injuries.
Therefore:
Make sure this equipment is put to use by skilled welding operators with sufficient
training and experience in spot welding, exclusively.
Before operation, consult the manual and make sure any and all preconditions are
fulfilled; any and all checks and preliminary works etc. have been carried out.
Work place must be clean and tidy – no clutter. Make sure you have enough room
to move.
Be sure to be wearing adequate PPE. ( see “2.2.3”.)
Check any and all connections. ( see “5”.)
Check input pressure. ( see “5.6”.)
Check cooling water level. ( see “5.2”.)
Check your tools / welding pliers). Re-tool now, if necessary.
( see “6.1.2” and / or separate operating instructions for welding pliers.)
Check status of the emergency stop pushbutton. ( see “2.6”.)
If you find the emergency stop button locked, check the welder and make sure it is
operational before you unlock the pushbutton. Turn clockwise (cw) to unlock.
To Next Page
Loading...
