Elektron MULTISPOT MI-100control - Calling up the Software Version; Calling up Current and Voltage Values

Resistance welder MULTISPOT MI-100control
Operation
64
6.7.2.7 Calling up the software version
Use the menu item “Software version” to display the current
version of the operating system.
You need the data for troubleshooting and for ordering wear
and spare parts.
Use the control knob to select “Software version”. Press to
confirm.
Fig. 87: Software version
You will see the message shown here on the left.
6.7.2.8 Calling up current and voltage values
Use the menu item “Measure mains supply” to display the
voltage drop.
You need the data for troubleshooting.
Use the control knob to select “Measure mains supply”.
Press to confirm.
Fig. 88: Current and voltage
You will see the data shown here on the left.