Elektron MULTISPOT MI-100control - Problems NOT displayed on the control panel

Resistance welder MULTISPOT MI-100control
Troubleshooting
78
7.2.2 Problems NOT displayed on the control panel
Message What’s the problem What should be done?
Who should
do it?
Welder does not boot up. Emergency stop pushbutton has
been pushed and is now locked.
Unlock pushbutton. Operator
Power cord not plugged in. Plug in power cord.
If the power cord is, indeed,
connected, a mains fuse may have
been triggered.
Reset fuse.
Display freezes.
LEDs not plausible.
System error. Reboot. Operator
The red LED to the left of
the control knob lights up.
Thermal overload. Let the welder cool off. Let
the cooling system run at
least 10 mins. After you
finish.
Operator
Tool error. Let the tool cool off. If
necessary, replace.
Mains disturbance. Check fuses and input
values ( “6.7.2.8”).