Resistance welder MULTISPOT MI-100control
Maintenance
84
8.3 Measures to be taken after maintenance
When you finish maintenance and before you switch the welder back on, carry out the following:
1. Re-establish any and all connections you loosened and / or removed before.
Check for tight fit.
2. Make sure any and all safety devices, covers etc. you may have removed are properly back
in place.
3. Make sure you have properly removed and taken away from the work area any and all tools,
materials etc. you may have used.
4. Clean the work area. If there have been any leaks, spills etc., clean up.
To Next Page
Loading...
