Elektron MULTISPOT MI-100control - Replacing water filter

Resistance welder MULTISPOT MI-100control
Maintenance
82
8.2.3 Replacing water filter
Scald hazard
DANGER!
Scalding may occur due to hot water coming out!
While pulling out the cooling water hoses hot water may come out.
Therefore:
 Wear gloves.
 Pull out water hoses carefully.
Slip hazard
DANGER!
Slip hazard due to water coming out!
While pulling out the cooling water hoses water may come out.
Therefore:
 Remove water from the floor.
Fig. 104: Water filter
1. Visually check the water filter (Fig. 104).
If you detect clear signs of dirt:
2. Switch off the welder. Wait, until the pump stops pumping.
3. Pull the water filter unit from the hoses to the top and
bottom.
4. Replace the old filter with a new one.
5. Insert the new water filter between the hoses.