ELNA eXpressive 970 - Winding the Bobbin

15
Winding the Bobbin
NOTE:
Cotton or spun polyester threads sizes 90 to 120 are
recommended for bobbin thread.
Do not use poor quality prewound bobbins.
z Place the thread cone (spool of thread) on the rear
most spool pin.
x Pass the thread through the thread guide A.
Pass the thread through the upper hole and lower hole
in the thread guide B.
q Thread guide A
w Thread guide B
z x
q
w
e
c
r
e
t
y
u
v b
n
m
,
i
u
t
u
y
t
c Draw the thread to the front.
Hold the thread with both hands and pass the thread
rmly around and under the tension disk.
e Tension disk
v Pass the thread through the hole in the bobbin from
the inside.
Put the bobbin on the bobbin winder spindle.
r Hole in the bobbin
t Bobbin winder spindle
b Push the bobbin winder stopper up against the
bobbin.
y Bobbin winder stopper
n Press the bobbin winding button while holding the
thread end.
u Bobbin winder button
m Press the bobbin winder button to stop the machine
when the bobbin has wound a few layers.
Cut the thread close to the bobbin and press the
bobbin winder button again.
u Bobbin winder button
, When the bobbin is fully wound, the machine will stop
automatically.
Remove the bobbin from the bobbin winder spindle.
t Bobbin winder spindle
Cut the thread with the bobbin thread cutter.
i Bobbin thread cutter
* Do not remove the thread from the bobbin thread
cutter after cutting the thread.