ELNA eXpressive 970 - Page 33

29
m Press the START/STOP button.
NOTE:
If you press the START/STOP button when the tension
release lever is in the open position, a warning sign
[W:03] will appear.
Pull the tension release lever up to close the tension
disk.
u Tension release lever
m
,
H:M1 ?
W: 03
. Press the START/STOP button to stop the machine.
Trim the thread at the beginning.
⁄0 Then, press the START/STOP button again.
, The LCD screen will show the reminder asking you to
conrm the hoop type to be used.
Check the hoop size and press the START/STOP
button again to sew a few stitches.
* If you press the MODE button, the previous screen
will be displayed.
. ⁄0
u