eMachines E644G - Using Dmitools

2-24 System Utilities
Using DMITools 0
The DMI (Desktop Management Interface) Tool copies BIOS information to EEPROM
(Electrically Erasable Programmable Read-Only Memory). Used in the DMI pool for hardware
management.
When the BIOS shows Verifying DMI pool data, it is checking that the table correlates
with the hardware before sending information to the operating system (Windows, etc.).
To update the DMI Pool, perform the following:
1. Boot to DOS.
2. Execute Dmitools.exe.
The following messages report to screen to confirm completion:
dmitools /r ==> Read dmi string from BIOS
dmitools /wm xxxx ==> Write manufacturer name to EEPROM (max. 16 characters)
dmitools /wp xxxx ==> Write product name to EEPROM (max. 16 characters)
dmitools /ws xxxx ==> Write serial number to EEPROM (max. 22 characters)
dmitools /wu xxxx ==> Write uuid to EEPROM
dmitools /wa xxxx ==> Write asset tag to EEPROM (max. 32 characters)
The following examples show the commands and the corresponding output information.
Read DMI Information from Memory
Input:
dmitools /r
Output:
Manufacturer (Type1, Offset04h): eMachines
Product Name (Type1, Offset05h): xxxxx
Serial Number (Type1, Offset07h): 01234567890123456789
UUID String (Type1, Offset08h): xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx
Asset Tag (Type3, Offset04h): Acet Asstag
Write Product Name to EEPROM
Input:
dmitools /wp eMachines
Write Serial Number to EEPROM
Input:
dmitools /ws 01234567890123456789
Write UUID to EEPROM (Create UUID from Intel WFM20.pdf)
Input:
dmitools /wu
Write Asset Tag to EEPROM
Input:
dmitools /wa Acet Asstag
NOTE:
NOTE:
When using any of the write options, restart the system to set the new DMI data.