Emotron VSB Series User Manual

Emotron VSB Instruction Manual Chapter 3 Installation and wiring
3.7 Control Terminal Wiring
WARNING
 Only qualified personnel familiar with AC motor drives are allowed to implement wiring.
Failure to comply may result in equipment damage and/or personnel injury even death.
 Wiring should be in strict accordance with this manual, otherwise hazard of electric
shock or equipment damage exists.
 Make sure input power supply has been completely disconnected before wiring
operation. Failure to comply will result in personnel injury even death.
 All wiring operations and lines should comply with EMC and national and local industrial
safety regulations and/or electrical codes. The conductor diameter should
be in
accordance with recommendations of this manual. Otherwise, hazard of equipment
damage, fire, and/or personnel injury exists.
 Screws or bolts for terminal wiring must be screwed tightly.
 AC 220V signal is prohibited from connecting to other terminals than control terminals
RA, RB and RC.
ATTENTION
 Signal wires should to the best of possibility be away from main power lines. If this
cannot be ensured, vertical cross arrangement should be adopted, reducing EMI
interference to the signal wires as much as possible.
- 24 -

Emotron VSB Series Specifications

General

Brand	Emotron
Model	VSB Series
Category	Controller
Language	English