Endress+Hauser Cerabar M PMC51 - Seals; Fill Fluid

Cerabar M PMC51, PMP51, PMP55
Endress+Hauser 105
Process isolating diaphragm
Device Designation Option
1)
PMC51 Al
2
O
3
aluminum oxide ceramic (FDA
2)
, USP Class VI+121°C), ultrapure 99.9 % (see also
www.endress.com/ceraphire)
Standard
PMP51 AISI 316L (DIN/EN material number 1.4435) A
AISI 316L with gold-rhodium coating M
Alloy C276 (DIN/EN material number 2.4819) B
PMP55 AISI 316L (DIN/EN material number 1.4435) A
AISI 316L, TempC E
AISI 316L with gold-rhodium coating M
AISI 316L with 0.25 mm (0.01 in) PTFE coating S
Alloy C276 (DIN/EN material number 2.4819) B
3)
Monel (2.4360) C
3)
Tantalum (UNS R05200) D
3)
1) Product Configurator, order code for "Membrane material"
2) The US Food & Drug Administration (FDA) has no objections to the use of ceramics made from aluminum
oxide as a surface material in contact with foodstuffs. This declaration is based on the FDA certificates of
our ceramic suppliers.
3) The material of the flange raised face is made of the same material as the process isolating diaphragm.
Seals
Type Designation Option
1)
PMC51 FKM Viton A
FKM Viton, FDA, 3A Class I, USP Class VI B
FFKM Perlast G75LT C
NBR F
HNBR, FDA, 3A Class II, KTW, AFNOR, BAM G
NBR, Low temperature H
EPDM, FDA J
EPDM, FDA, 3A Class II, USP Class VI+121°C, DVGW, KTW, W270, WRAS, ACS, NSF61 K
FFKM Kalrez 6375 L
FFKM Kalrez 7075 M
FFKM Kalrez 6221, FDA, USP Class VI N
Fluoroprene XP40, FDA, USP Class VI+121°C, 3A Class I P
VMQ Silicone, FDA S
1) Product Configurator, "Seal" ordering feature
Fill fluid
Designation Option PMP51
1)
Silicone oil 1
Inert oil 2
Synthetic oil as per FDA 21 CFR 178.3620 (b)(1) and NSF H-1 3
1) Product Configurator, order code for "Fill fluid"