Cerabar M PMC51, PMP51, PMP55
70 Endress+Hauser
PMP51: process connections
with flush-mounted process
isolating diaphragm
ASME flanges, connection dimensions as per ASME B 16.5, raised face RF*
A0022645
D Diameter of flange
b Thickness
g Raised face
c Raised face
k Hole circle
g
2
Diameter of hole
d
M
Max. diaphragm diameter
Engineering unit in.
(*all apart from AN, see table below)
Flange
1)
Boltholes Weight Approval
2)
Option
3)
Nominal diameter Class/nominal pressure D b g c m Quantity g
2
k
[in] lb./sq.in [in] [in] [in] [in] [in] [in] [in] [kg (lb)]
1 300 4.88 0.69 2
4)
0.06 0.2 4 0.75 3.5 1.3 (2.87) CRN ANJ
1 ½ 150 5 0.69 2.88
4)
0.08 0.52 4 0.62 3.88 1.5 (3.31) CRN AEJ
1 ½ 300 6.12 0.81 2.88
4)
0.08 0.52 4 0.88 4.5 2.6 (5.73) CRN AQJ
2 150 6 0.75 3.62 0.08 - 4 0.75 4.75 2.4 (5.29) CRN AFJ
2 300 6.5 0.88 3.62 0.08 - 8 0.75 5 3.2 (7.06) CRN ARJ
3 150 7.5 0.94 5 0.08 - 4 0.75 6 4.9 (10.8) CRN AGJ
3 300 8.25 1.12 5 0.08 - 8 0.88 6.62 6.7 (14.77) CRN ASJ
4 150 9 0.94 6.19 0.08 - 8 0.75 7.5 7.1 (15.66) CRN AHJ
4 300 10 1.25 6.19 0.08 - 8 0.88 7.88 11.6 (25.88) CRN ATJ
1) Material: AISI 316/316L; Combination of AISI 316 for required pressure resistance and AISI 316L for required chemical resistance (dual rated)
2) CSA approval: Product Configurator, "Approval" ordering feature
3) Product Configurator, "Process connection" section
4) With these process connections the raised face is smaller than described in the standard. Due to the smaller raised face, a special seal must be
used.
To Next Page
Loading...
