Endress+Hauser Cerabar M PMC51 - Ordering Information; Special Device Versions; Scope of Delivery; Measuring Point (TAG)

Cerabar M PMC51, PMP51, PMP55
124 Endress+Hauser
Ordering information
Detailed ordering information is available as follows:
• In the Product Configurator on the Endress+Hauser website:www.endress.com → Click "Corporate"
→ Select your country → Click "Products" → Select the product using the filters and search field →
Open product page → The "Configure" button to the right of the product image opens the Product
Configurator.
• From your Endress+Hauser Sales Center:www.addresses.endress.com
Product Configurator - the tool for individual product configuration
• Up-to-the-minute configuration data
• Depending on the device: direct input of information specific to the measuring point, such as
measuring range or operating language
• Automatic verification of exclusion criteria
• Automatic generation of the order code with its breakdown in PDF or Excel output format
• Ability to order directly in the Endress+Hauser Online Shop
Special device versions
Endress+Hauser offers special device versions as Technical Special Products (TSP).
For further information please contact your local Endress+Hauser Sales Center.
Scope of delivery
• Device
• Optional accessories
• Brief Operating Instruction
• Calibration certificates
• Optional certificates
Measuring point (TAG)
Order code for 895: Marking
Option Z1: Tagging (TAG), see additional spec.
Location of measuring point
identification
To be selected in the additional specification:
• Tie-on label, stainless steel
• Adhesive paper label
• Label provided
• RFID TAG
• RFID TAG + tie-on label, stainless steel
• RFID TAG + adhesive paper label
• RFID TAG + label provided
Definition of measuring point
identification
To be specified in additional specification:
3 lines each with a maximum of 18 characters
The measuring point designation appears on the selected label and/or the
RFID TAG.
Identification on electronic
nameplate (ENP)
32 characters
Identification on display
module
10 characters
Configuration data sheet
(HART, PROFIBUS PA,
FOUNDATION Fieldbus
electronics)
Pressure
If the option "J" was selected for the order code for "Calibration; Unit" in the Product Configurator, the
following configuration data sheet must be completed and included with the order.
Pressure unit



mbar
bar
psi




mmH
2
O
mH
2
O
ftH
2
O
inH
2
O


mmHg
kgf/cm
2



Pa
kPa
MPa