Cerabar M PMC51, PMP51, PMP55
112 Endress+Hauser
Profiboard
For connecting a PC to the PROFIBUS.
Proficard
For connecting a laptop to the PROFIBUS.
FF configuration program
FF configuration program, such as NI-FBUS Configurator, to
• connect devices with "FOUNDATION Fieldbus signal" into an FF-network
• set FF-specific parameters
Operation with NI-FBUS Configurator:
The NI-FBUS Configurator is an easy-to-use graphical environment for creating linkages, loops, and
a schedule based on the fieldbus concepts.
You can use the NI-FBUS Configurator to configure a fieldbus network as follows:
• Set block and device tags
• Set device addresses
• Create and edit function block control strategies (function block applications)
• Configure vendor-defined function and transducer blocks
• Create and edit schedules
• Reading and writing of data from control and regulation systems
• Invoke methods specified in the manufacturer-specific DD (e.g. basic device settings)
• Display DD menus (e.g. tab for calibration data)
• Download a configuration
• Verify a configuration and compare it to a saved configuration
• Monitor a downloaded configuration
• Replace a virtual device by a real device
• Save and print a configuration
System integration (Except
analog electronics)
The device can be given a tag name (max. 8 alphanumeric characters)
Designation Option
1)
Tagging (TAG), see aditional spec. Z1
Bus address, see aditional spec. Z2
1) Product configurator "Marking" ordering feature
To Next Page
Loading...
