Endress+Hauser Cerabar M PMC51 - Drinking Water Approval; Classification of Process Sealing between Electrical Systems and (Flammable or Combustible) Process Fluids in Accordance with ANSI; ISA 12.27.01; Inspection Certificate; Calibration; Unit

Cerabar M PMC51, PMP51, PMP55
122 Endress+Hauser
Designation Option
1)
LR (Lloyd's Register ) LG
BV (Bureau Veritas) LH
DNV (Det Norske Veritas) LI
1) Product Configurator, "Additional approval" ordering feature
Drinking water approval
NSF 61 - approval forPMC51 and PMP51
UBA / W270 - approval for PMC51 and PMP51
Ordering information:
Product Configurator, "Additional approval" ordering feature, option "LR"
Classification of process
sealing between electrical
systems and (flammable or
combustible) process fluids
in accordance with ANSI/ ISA
12.27.01
Endress+Hauser instruments are designed according to ANSI/ISA 12.27.01 either as single seal or
dual seal devices with annunciation, allowing the user to waive the use and save the cost of installing
external secondary process seals in the conduit as required by the process sealing sections of ANSI/
NFPA 70 (NEC) and CSA 22.1 (CEC). These instruments comply with the North-American
installation practice and provide a very safe and cost-saving installation for pressurized applications
with hazardous fluids.
Further information can be found in the control drawings of the relevant devices.
Inspection certificate
Designation PMC51 PMP51 PMP55 Option
1)
3.1 Material certificate, wetted metallic parts, EN10204-3.1 inspection
certificate
   JA
2)
Conformity to NACE MR0175, wetted metallic parts    JB
2)
Conformity to NACE MR0103, wetted metallic parts    JE
2)
Conformity to AD2000, wetted metallic parts, excepting process
membrane
―   JF
Surface finish measurement ISO4287/Ra, wetted metallic parts,
Inspection certificate
   KB
Helium leak test, internal procedure, inspection certificate    KD
Pressure test, internal procedure, inspection certificate    KE
3.1 Material certificate+Delta-Ferrit measurement, internal procedure,
wetted metallic parts, EN10204-3.1 inspection certificate
   KF
3.1 Material certificate+PMI test (XRF), internal procedure, wetted
metallic parts, EN10204-3.1 inspection certificate
―   KG
Welding documentation, wetted/pressurized seams ―  ― KS
1) Product Configurator, "Test, certificate" ordering feature
2) The selection of this feature for coated process isolating diaphragm / process connections refers to the
metallic base material.
Calibration; unit
Designation Option
1)
Sensor range; % A
Sensor range; mbar/bar B
Sensor range; kPa/MPa C
Sensor range; mm/mH2O D
Sensor range; inH2O/ftH2O E
Sensor range; psi F