Cerabar M PMC51, PMP51, PMP55
Endress+Hauser 119
Certificates and approvals
CE mark
The device meets the legal requirements of the relevant EC directives. Endress+Hauser confirms that
the device has been successfully tested by applying the CE mark.
RoHS
The measuring system complies with the substance restrictions of the Restriction on Hazardous
Substances Directive 2011/65/EU (RoHS 2).
RCM-Tick marking
The supplied product or measuring system meets the ACMA (Australian Communications and Media
Authority) requirements for network integrity, interoperability, performance characteristics as well
as health and safety regulations. Here, especially the regulatory arrangements for electromagnetic
compatibility are met. The products are labelled with the RCM- Tick marking on the name plate.
A0029561
Ex approvals
• ATEX
• IECEx
• FM
• CSA
• NEPSI
• Also combinations of different approvals
All explosion protection data are given in separate documentation which is available upon request.
The Ex documentation is supplied as standard with all devices approved for use in explosion
hazardous areas → 128.
EAC conformity
The measuring system meets the legal requirements of the applicable EAC guidelines. These are
listed in the corresponding EAC Declaration of Conformity together with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the EAC mark.
Suitable for hygiene
applications
The device has been developed for use in hygienic processes.
The materials in contact with the process meet FDA requirements as well as the 3-A Sanitary
Standard No. 74-XX. Endress+Hauser confirms compliance with the requirements by affixing the 3-
A mark to the device.
The following serial number-specific declarations (with a copy of the certification) can be ordered
with the device (optional):
Product Configurator, order code for "Additional approval" option "LD"
Product Configurator, order code for "Additional approval" option "LB"
NOTICE
Risk of contamination if incorrect seals and parts are used!
‣
To avoid the risk of contamination, the device must be installed in accordance with EHEDG
"Hygienic Equipment Design Criteria (HDC)", "Subgroup Design Principles" Doc. 8.
‣
Suitable assemblies and seals must be used to ensure hygiene-compliant design according to the
specifications of 3-A SSI and EHEDG Position Paper (in their current version).
‣
The leak-proof connections can be cleaned with the cleaning methods typical of this industry
(CIP and SIP). Attention must be paid to the pressure and temperature specifications of the
sensor and process connections for CIP and SIP processes (clean in place/sterilization in place).
‣
For diaphragm seal devices with 3-A and EHEDG certificates, only select filling oils with FDA
approval!
To Next Page
Loading...
