Endress+Hauser Proline 200 - Page 107

Proline Prowirl F 200 PROFIBUS PA Commissioning
Endress+Hauser 107
Parameter Prerequisite Description Selection / User
entry
Factory setting
Failure mode In the Operating mode
parameter, the Pulse option is
selected and one of the
following options is selected in
the Assign pulse output
parameter (→  106):
• Volume flow
• Corrected volume flow
• Mass flow
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Define output behavior in
alarm condition.
• Actual value
• No pulses
No pulses
Invert output signal – Invert the output signal. • No
• Yes
No
* Visibility depends on order options or device settings