Endress+Hauser Proline Promag H 300 - Page 99

Proline Promag H 300 PROFINET Commissioning
Endress+Hauser 99
Configuring the switch output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  99
Terminal number
→  99
Signal mode
→  99
Switch output function
→  100
Assign diagnostic behavior
→  100
Assign limit
→  100
Assign flow direction check
→  100
Assign status
→  100
Switch-on value
→  100
Switch-off value
→  100
Switch-on delay
→  100
Switch-off delay
→  101
Failure mode
→  101
Invert output signal
→  101
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
• Frequency
• Switch
Pulse
Terminal number – Shows the terminal numbers
used by the PFS output
module.
• Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–
Signal mode – Select the signal mode for the
PFS output.
• Passive
• Active
• Passive NAMUR
Passive