ENSONIQ DP/4 - Page 64

48
Section 3 - Config Parameters
04 - (Config Dependent)
This parameter is dependent on how Units A and B are routed (determined by parameter 02). If
parameter 02 is serial, this screen shows:
Path I=Iround
=00
This screen allows you to control an external dry signal around Units A and B. A setting of 00
would not allow a dry signal around the units, whereas a setting of 99 would permit a full signal
around the units.
Dry
I A Wcl 8 ~I--'-'.
This parameter controls this amount.t
If parameter 02 is feedback 1 or 2, this screen shows:
Feedback B to 1=1
I=IMount =00
This screen allows you to control a feedback signal from Units B to the front of Unit A. A setting
of
00 would not allow the feedback signal back into the units, whereas a setting of 99 would
permit a full feedback signal.
~ A I Wm I 8 II
1 ~ Feedback
/ This parameter controls this amount.
If parameter 02 is parallel, this screen shows:
(unconnected)
I=IB RMt =00
This parameter does nothing because of the nature of a parallel connection, there is no dry path
(or feedback) around the units.
ENSONIQ DP/4 Musician's Manual
-