ENSONIQ DP/4 - Page 69

Section 3 - Config Parameters
04 - (Config Dependent)
This parameter is dependent on how Units C and D are routed. See the description about config
dependent parameters under 1 Source Config (parameter 04) for more information.
nr
U:t
(b)ypass (k)ill
i=I=b B=b C=b D=b
05 - Bypass Kill (Unit) A
06 - Bypass Kill (Unit) B
07 - Bypass Kill (Unit) C
08 - Bypass Kill (Unit) 0
These parameters determine what happens when you bypass a unit (the red LED is lit). When set
to bypass (b), only the dry signal passes through the unit. When set to kill (k), no signal passes
through the unit.
ENSONIQ DP/4 Musician's Manual 53