Enterasys K6 User Manual

Installing and Removing a Power Supply
Enterasys K-Series K6 Chassis Hardware Installation Guide 3-15
Figure 3-13 Removing a Coverplate from a K-AC-PS-1400W Power Supply Slot
Removing a Power Supply
Wheneverpossible,youshouldinstallareplacementpowersupplybeforeremovingapower
supply.
ToremoveaK‐AC‐PS‐1400Wpowersupply:
1. Attachtheanti‐staticwriststrapasdescribedin“AttachingtheElectrostaticDischargeWrist
Strap”onpage 3‐12beforehandlingthepowersupply.
2. Unplugthepowercordfrom
thededicated ACoutlet.
3. UnplugthepowercordfromtheACpowerconnectorofthepowersupply.
4. Unscrewthecaptivescrewstoreleasethepowersupplyfromthechassis.
5. Graspthepowersupplyhandleandpullthepowersupplystraightoutofthechassis.
6. Placethepowersupplyonanantistaticsurfaceor
inanantistaticbagforfutureuse.
1 Power supply slot 3 Captive screw
2 Coverplate
Caution: If you plan to operate the chassis with only one power supply, make sure to install the
coverplate in place of the removed power supply to reduce Electromagnetic Interference.
Precaución: Si desea trabajar sólo con una fuente de poder, no olvide colocar la tapa en el
compartimiento de la fuente de poder que haya eliminado, para reducir la interferencia
electromagnética.

Enterasys K6 Specifications

General

Brand	Enterasys
Model	K6
Category	Chassis
Language	English