Enterasys K6 - K-Series Startup Screen Example

Completing the Installation
3-34 Chassis Setup
StarttheCommandLineInterface(CLI)fromthefabriccard’sconsoleportasfollows:
1. Connectaterminaltothelocalconsoleportasdescribedin“ConnectingtotheFabricCard
COMPortforLocalManagement”onpage 3‐27.Thestartupscreen,Figure 3‐31,displays.
2. Attheloginprompt,enterone
ofthefollowingdefaultusernames:
– roforRead‐Onlyaccess,
– rwforRead‐Writeaccess,or
– adminforSuperUseraccess.(ThisaccesslevelallowsRead‐Writeaccesstoallmodifiable
parameters,includinguseraccounts.)
3. PressENTER.
4. ThePasswordpromptdisplays.LeavethisstringblankandpressENTER.Thefabric
card
informationandKChassispromptdisplaysasshowninFigure 3‐31.
TheK‐Serieschassisisnowreadytobeconfigured.ForinformationaboutsettingtheIPaddress
andconfiguringTelnetsettingsforremoteaccesstoK‐Serieschassismanagement,refertothe
EnterasysK‐SeriesConfigurationGuide.The
CLIcommandsenableyoutoinitiallysetupand
performmoreinvolvedmanagementconfigurations.
TheEnterasysK‐SeriesConfigurationGuideisavailableonlineat:
https://extranet.enterasys.com/downloads/
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribedin
“GettingHelp”onpage xvii.
Figure 3-31 K-Series Startup Screen Example
login: admin
Password:
K6
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2009
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx
K Chassis(su)->