Enterasys K6 - Completing the Installation of a K-Series Fabric Card in an Existing Chassis

Completing the Installation
Enterasys K-Series K6 Chassis Hardware Installation Guide 3-35
Completing the Installation of a K-Series Fabric Card in an Existing
Chassis
WhenyouinstallanewK‐SeriesfabriccardintoaK‐Serieschassiswithanexistingconfigured
useraccount,thecurrentsystemsettingsinthataccountarealreadyrecognizedbythenew
K‐Seriesfabriccardanditwilloperateaccordingly.
Ifyouneedtochangeanysettings,youcan
connectaterminaltothelocalconsoleportas
describedin“ConnectingtotheFabricCardCOMPortforLocalManagement”onpage 3‐27to
accesssystemmanagement,oruseaTelnetconnectiontoaccesstheK‐Seriesfabriccardsystem
managementasdescribedintheEnterasysK‐Series
ConfigurationGuide.
Logging in with an Administratively-Configured User Account
Ifthedevice’sdefaultuseraccountsetting shavebeenchanged,proceedasfollows:
1. Attheloginprompt,enteryouradministratively‐assignedusernameandpressENTER.
2. AtthePasswordprompt,enteryourpasswordandpressENTER.
ThenoticeofauthorizationandtheKChassispromptdisplaysasshownbackinFigure 3‐31.
Note: Users with Read-Write (rw) and Read-Only access can use the set password command to
change their own passwords. Administrators with Super User (su) access can use the set system
login command to create and change user accounts, and the set password command to change
any local account password. For information on the set password and set system login commands,
refer to the EnterasysK‐SeriesConfigurationGuide.