Enterasys K6 - Connecting Power

Connecting Power
3-26 Chassis Setup
4. Slidethelinecardoutofthechassis.SeeFigure 3‐26.
Figure 3-26 Removing a Line Card
5. Ifyouarenotinstallinganotherlinecardintheslot,installalinecardcoverplateovertheslot
toensureproperairflow.
Orientthelinecardcoverplatesothatthekeyonthecoverplateis
atthebottom.See
Figure 3‐27.
Figure 3-27 Line Card Cover Plate Key
Connecting Power
TopoweruptheK6chassiswithK‐AC‐PS‐1400 Wpowersupplies:
1 Line card cover plate key
Note: If multiple power supplies are installed, repeat the following procedure for each supply.
For redundancy using multiple K-AC-PS-1400W power supplies, each of the power cords from the
power supplies must be connected to dedicated 15 A AC power circuits.