Enterasys K6 - Line Card Port LEDs

LEDs
Enterasys K-Series K6 Chassis Hardware Installation Guide 4-3
Table 4‐2describestheLEDindicationsfortheRXandTXLEDsforthefabriccardSFP+portsand
providesrecommendedactions.
Line Card Port LEDs
YoucanviewthereceiveandtransmitactivityontheRXandTXLEDsforthelinecardRJ45,SFP,
andSFP+ports.SeeFigure 4‐3.
Figure 4-3 Line Card Port LEDs
Table 4-2 Fabric Card Port LEDs
LED Color State Recommended Action
RX
(Receive)
None No link. No activity. Port enabled or
disabled.
None.
Green Solid. Link present, port enabled, no
traffic is being received by the interface.
None.
Yellow Blinking. Link present, port enabled,
traffic is being received by the interface.
None.
TX
(Transmit)
None Port enabled, but no activity. If you know the port should be
active and is not, contact
Enterasys Technical Support.
Green Blinking. Indicates data transmission
activity. Flashing frequency indicates the
data rate.
None.
Yellow Solid. Fault or error (collision). None, unless activity is high; in
which case, check for network
configuration problems or a
defective device.
1 RJ45 port RX LEDs 3 SFP RX LED for
bottom port
5 SFP TX LED for
bottom port
7 SFP+ RX LED
2 RJ45 port TX LEDs 4 SFP RX LED for top
port
6 SFP TX LED for top
port
8 SFP+ TX LED