Enterasys K6 - Required Tools

Required Tools
3-2 Chassis Setup
Required Tools
•ESDwriststrap(includedwiththeK6chassis)
• Phillipsscrewdriver
APhillipsscrewdriverisneededtoinstalltheunitina48.26‐centimeter(19‐inch)equipmentrack.
RefertoChapter 2,InstallationRequirementsandGuidelines,forinstallationguidelines.
Unpacking the K Chassis
TheK6chassisispackedandshippedinaboxwithoutaskid.Beforeunpackingthechassis,
examinetheoutsidepackagingforobviousdamage.
TounpacktheK6chassis:
1. Openthebox.
2. Removeandsavetheaccessorypackage,documents,andcablefromthetopofthestyrofoam
cap.SeeTable 3‐1.
3. Lift
andremovethestyrofoamcapfromthetopofthechassis.
4. Openthetopoftheshippingbagcoveringtheunit,thenpullthebagdownaroundthe
chassis.
5. Liftandremovethechassisfromthebox.
Saveallshippingmaterialsforfuturereshipping,ifnecessary.
6. Inspectthechassisforanysigns
ofphysicaldamage.
Ifthereareanysignsofdamage,DONOTinstallthechassis;instead,contactEnterasys
Networks.Referto“GettingHelp”onpage xviifordetails.
Note: Unpack the K6 chassis components only as needed. Leave the components in their
respective shipping cartons until you are ready to install that component. Save all shipping
materials in the event that the chassis has to be repacked.
Table 3-1 Accessories That Ship with the K-Series Chassis
Item
Electrostatic discharge (ESD) wrist strap
Installation documentation
Rubber feet and screws
RJ45 console port cable
RJ45-to-DB9 adapter
Cable management clips