Enterasys S Series - Appendix D: Installing the SSA-WALL-MOUNT

Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide D-1
D
Installing the SSA-WALL-MOUNT
This appendix provides instructions for installing the SSA on a wall using the optional
SSA-WALL-MOUNT kit.
Required Tools
• ESD wrist strap (included with the SSA chassis)
• Phillips screwdriver
Contents of SSA-WALL-MOUNT Kit
Table D-1 lists the contents of the SSA-WALL-MOUNT kit.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Risques d'électrocution:Seul un personnel qualifié doit effectuer les procédures d'installation.
For information about... Refer to page...
Required Tools D-1
Contents of SSA-WALL-MOUNT Kit D-1
Installation Site Requirements D-2
Preparing the Installation Site D-2
Mounting the SSA Chassis on a Wall D-4
Table D-1 Contents of SSA-WALL-MOUNT Kit
Item Number
Mounting bracket 1
10-32 x .5 inch pan head screws 2