Epson SC-F2000 - Page 115

SC-F2000 Revision C
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 115
Confidential
INSTALLING THE SPONGE
1. Install the sponge (1) in the pedestal of the HEAD FFC.
Figure 3-64. Installing the sponge (1)
2. Connect the HEAD FFC to the connectors of the PRINT HEAD.
x
Figure 3-65. Connecting the HEAD FFC
3. Install the sponge (2) in the HEAD FFC. The HEAD FFC are pinched the sponge
(1) and the sponge (2).
Figure 3-66. Installing the sponge (2)
C H E C K
P O I N T
 Make sure to connect the FFCs to the correct connectors.
 When connecting the FFCs, make sure the terminals of CN2
and CN4 are facing outwards.
Sponge (1)
Stick
PRINT HEAD
Pedestal
HEAD FFC
HEAD FFC
Connector
Stick
Sponge (2)