Epson SC-F2000 - Page 164

SC-F2000 Revision C
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 164
Confidential
Figure 3-127. Removing the RIGHT INK HOLDER ASSY (2)
D
D
Rear side
C
B
RIGHT INK HOLDER ASSY
 Before installing the joint, make sure the Joint Rubbers are
attached to it.
 Before attaching the Joint Rubber, let it get wet with cleaning
liquid.
 Make sure to tighten the screw that secures the tube of the
RIGHT INK HOLDER ASSY using a torque driver with the
following torque.
0.39 ± 0.05 N/m
 Always use new Joint Rubbers.
 Insert only Joint Rubber per line between upper Joint and
lower Joint.
 Confirm there are no foreign objects attached on the Joint
Rubbers.
Joint Rubber